Press Preset Button ” 4 ” repeatedly for 4th Digit of your Keycodeįor the next part entering the code is different depending on the radio model.Įx1: In the end you hold pressed the 6 key until it beeps for validating the code.Įx2:If the display now shows the correct Ke圜ode number then: Press Preset Button ” 5 ” to Enter Press Preset Button ” 3 ” repeatedly for 3rd Digit of your Keycode Press Preset Button ” 2 ” repeatedly for 2nd Digit of your Ke圜ode Press Preset Button ” 1 ” repeatedly for 1st Digit of your Ke圜ode Then enter it using 1,2,3,4 keys on the radio, one key per letter of the code. So, remove the radio from the board, read the serial code, enter it in the Radio Code Calculator and the app will return a unlock code for radio. Radio CD-DVD serial is written on the label, and the label is located or on the back of the radio, or on one side, and we need this serial number code. Like any part of the car and the radio and has a code (serial). Do not call anyone, not go to anyone, only use an application: Radio Code Generator. So you start looking online, information that will help in this case. The solution would be to go to a representative of the car and there you will receive the code for the radio. Well, many, we may not have radio code at all (we lost it, bought a second hand car and was not included, you entered a wrong code too many times, etc).

You remain without the car battery or change the battery, and radio no longer starts, asks you to enter the code! Normally the radio code have been noted somewhere on the manuals that you’ve got with the car, or you have a card that contains the code for the radio. Make sure to enter a Plausible WorkShopCode (WSC) like 12345 on the Coding Screen, new or reflashed RNS510 units may have a WSC 00000 stored which results in a 01042 - Control Module Not Coded Fault Code.I am convinced that many of us needed a car radio code at least once in a lifetime.Due to different Control Modules and Equipment in the Car the actual Coding Table is not shown here but will automatically be used by the Long Coding Assistant once you access the Function using VCDS.Update the Navigation System (J506 / #37) Coding.Even though Address 56 - Radio is registered, the RNS310 will NOT communicate via that Address - you have to use 37 - Navigation instead. Address 56 - Radio should also be activated in case there was no Radio installed prior to the Retrofit. Register the newly added 37 - Navigation Control Module, in case you had a Navigation System installed before the Retrofit this step may not be necessary.Update the Installation List in the Gateway (J533 / #19).The following Activations are necessary to ensure that the newly fitted parts are properly recognized and are ready to use.

Calculator code rns315 rns310